Kingstone retaining wall repair tips: By using NFC you are basically increasing the depth of your retaining wall. Most masonry blocks would be an average depth of 200-250mm, by using NFC you are increasing that depth of your solid masonry block from 200mm up to 500mm (Infill depth) or more depending on the height of your wall. It is always recommended that every third or fourth block should have part of the back edge removed. This would give a far better adhesion tying the NFC infill layer and the NFC core filled blocks creating a far stronger structure.
Anyone with a strong back can stack up a bunch of blocks and build a pretty stone retaining wall. But it takes skill and planning to construct an attractive wall that can also handle immense pressure, shrug off the forces of gravity, stand for decades and laugh in the face of Mother Nature. That’s the kind of wall we wanted to learn how to build, so we went to work with some hardworking hardscaping pros. They showed us that it’s all about a solid base, proper drainage and the right materials for the job. They also shared a few handy tips they’ve picked up over the years.
DON’T forget to allow for drainage. Groundwater is the natural enemy of retaining walls. When it saturates clay-type soils, they swell and put excessive pressure on the backside of the wall. To avoid failure, make drainage provisions at the same time as you go about building the retaining wall. Backfilling the space behind the blocks with crushed stone and then installing a flexible perforated drainpipe (available at The Home Depot), also called “drain tile,” at the base of the wall could create the necessary escape route for groundwater. The perforated pipe will carry groundwater to each end of the wall where it can drain harmlessly away. The ends of the drainpipe should then exit on each end of the wall, and you may cover them with crushed stone to camouflage their appearance.
To ensure the utmost strength, any wall taller than four feet should be carefully designed prior to installation. You have to consider structural reinforcement, drainage and the wall’s overall stability. Tall walls should all be designed for a “battering” effect, where the courses are set back from one another. In other words, the wall slants backwards as it gets taller. This battering effect adds life to a wall that may eventually tilt forward over time from the pressure of the earth behind it. Although battering is one method of strengthening a wall, most segmental systems incorporate this approach in conjunction with the other reinforcement measures mentioned above-reinforcement grids, anchors or steel reinforcement. See extra info on https://retainingwallscolorado.com/.
We also repair existing retaining walls. Many railroad tie walls or older concrete retaining walls which may or may not include rocks or boulders are beginning to show signs of failure. Often times a homeowner will build a DIY retaining wall that needs help after years of service. We serve all of Colorado out of our home office in Colorado Springs. Please feel free to reach out to us with any questions you may have. Estimates are always free and everything we touch comes with a warranty